JUM 109A Non-Methane Hydrocarbon (NMHC) / Total Hydrocarbon (THC) Analzyer

The JUM Engineering Model 109A uses two individual detectors and two individual signal amplifiers. Sample is introduced into one FID for THC reading. The same sample is also run through a non-methane cutter which eliminates all hydrocarbons except methane. This sample is run through FID #2. The analyzer subtracts the two numbers to give you a THC less methane reading. This item is also available for rent from CleanAir Europe.

Overview

Range: 

0-10ppm up to 0-100,000ppm

Outputs: 
2 individual 0-10V
Power: 
120 v AC, 60Hz, 1100watts
Shipping Weight: 
70 lbs.

Helpful Hints

Helpful Hints: 
The JUM 109A requires a fuel supply but has an internal charcoal filter for creating combustion air. In areas suspected to have high methane background, a cylinder of zero air is recommended. Allow the analyzer to fully warm up before igniting the flame. Three methane cal gases and one propane cal gas are recommended to calibrate both channels.

Download Detailed Specifications

Detailed Specifications: 

Photos

Featured Photos: